Data Port Configuration On The Meridian 1 Pbx - Nortel Remote Gateway 9150 Installation And Administration Manual

Sample configuration files

Data port configuration on the Meridian 1 PBX

This section shows the configuration settings for the data port on the Meridian 1
PBX. The data port provides the communication path between the RLC and the
Remote Gateway 9150 unit, and must be configured as an MCA.
Configuration example
This configuration example uses the settings identified in the network diagram
shown on page 391.
Note: This configuration sample is from a Meridian 1 PBX 11.
REQ: prt
TYPE: 2616
TN 5 16
DES
DES Remote site 1
TN 005 0 00 16
TYPE 2616
CDEN 8D
CUST 0
AOM 0
FDN
TGAR 1
LDN NO
NCOS 0
SGRP 0
RNPG 0
SCI 0
SSU
XLST
CLS CTD FBD WTD LPR MTD FND HTD ADD HFD
MWD LMPN RMMD SMWD AAD IMD XHD IRD NID OLD DTA DRG1
POD DSX VMD CMSD CCSD SWD LND CNDD
CFTD SFD MRD DDV CNID CDCA MSID DAPA BFED RCBD
ICDD CDMD LLCN MCTD CLBD AUTU
GPUD DPUD DNDD CFXD ARHD CLTD ASCD
CPFA CPTA ABDD CFHD FICD NAID BUZZ AHD
DDGA NAMA
DRDD EXR0
USMD USRD ULAD RTDD RBDD RBHD PGND FLXD FTTC DNDY DNO3
394
Telephone type
RLC slot and port numbers
TGAR must be configured to allow trunk
access. Refer to your PBX
documentation for more details.
DTA defines the port as a data port.
Remote Gateway 9150 Installation and Administration Guide
Standard 4.0