Configuring Stations - Nortel Remote Gateway 9150 Installation And Administration Manual

Configuring the Remote Gateway 9150 unit

Configuring stations

To configure stations:
1 Locate the port that you want to configure by clicking on the appropriate
port range tab, and then scrolling down the list.
The following table describes port number ranges and how they can be
configured:
Ports
0–15 and 32–47
16–31 and 48–63
64
Note: You can use ports 32 through 47 and 48 through 63 only if this
Remote Gateway 9150 unit connects to a 2-slot RLC on the host PBX.
2 Under Port Type, click on the option button of the call processing capability
that this station is to have:
Local: if only calls through the local PSTN are allowed. This option
enables the Configure button for this port.
Remote: if only calls through the host PBX are allowed.
Local and Remote: if both local and remote calls and local station-to-
station calling are allowed. This option enables the Configure button for
this port so you can configure local station features and keys.
Note: Choose Local and Remote if you want to define a Bridge Port.
3 Accept the default RLC Port associated with this station, or enter a new
RLC port number.
Exception: Do not associate a local-only port with an RLC port.
208
Can be assigned to
digital telephones.
Note: The associated ports on the host PBX
must be configured with voice capability.
stations equipped with ATAs or MCAs.
Note: The associated ports on the host PBX
must be configured with data capability.
a fax machine or other analog device
(without an ATA).
Note: The associated port on the host PBX
must be configured with voice capability.
Remote Gateway 9150 Installation and Administration Guide
Standard 4.0