Module Identification; Device Configuration; Configuring Dsps - Nortel Remote Gateway 9150 Installation And Administration Manual

Configuring the Remote Gateway 9150 unit

Module identification

The upper portion of the DSP configuration property sheet displays fields that
identify the module you are currently configuring. In the Module Number drop
down box, choose the module position on the Remote Gateway 9150 unit that
the DSP module occupies. Module 0 represents the built-in DSP resources on
the Remote Gateway 9150 unit–the equivalent of one DSP application module.

Device configuration

The middle portion of the property sheet displays information describing the
DSP loads, and corresponding compression algorithms that you can select for
each DSP device.

Configuring DSPs

To configure DSPs on your Remote Gateway 9150 unit, complete the following
steps:
1 Access the DSP Configuration property sheet.
2 Complete the fields as described in "DSP Configuration field descriptions"
on page 241.
3 Click on the OK button
Result: Configuration Manager writes the changes to a temporary file on
the administration PC.
4 Click on the Send button to update the Remote Gateway 9150 unit with the
new information.
Note: To save changes to the Remote Gateway 9150 unit's Flash memory,
select Upload
240
→
Save to Flash from the Menu Bar.
Remote Gateway 9150 Installation and Administration Guide
Standard 4.0