Succession 1000M, Succession 1000, And Meridian 1 Configuration - Nortel Meridian Meridian 1 Implementation Manual

Page 42 of 208
Procedure 1
Prepare for the installation
1
2
3
4
5
Take inventory
After unpacking and inspecting the equipment, verify that all necessary
components are on site before beginning the installation. Check the
equipment received against the shipping documents. Report any
missing parts to your Nortel Networks representative.
Verify IPE Slot(s)
The MICB card can be installed in any IPE card slot associated with full
50-pin I/O cables. Table 5 lists the system modules and the card slots
appropriate for MICB installation.
Table 5
MICB installation into card slots
System modules
NT8D37BA/EC IPE modules, and
NT8D11BC/ED CE/PE modules.
NT8D37AA/DC IPE modules.
Succession 1000
Determine the access method
Select the access method, single-number or direct meeting access, the
system will be using. With direct access, configure 10 DN pairs. In
single-number access mode, configure only the single-access DN. In
both cases, the BUI provides instructions about what to do next.

Succession 1000M, Succession 1000, and Meridian 1 configuration

Prior to installing any of the MICB hardware, configure the system
software for the MICB card(s) through the system TTY terminal.
553-3001-358 Standard 1.00
Remove items from the installation site that can generate static charge.
Use antistatic spray if the site is carpeted.
Ground yourself before handling any equipment.
Remove equipment carefully from its packaging. Save the packaging, in case
the card has to be returned.
Inspect the equipment for faults or damage. Report any damaged component
to your Nortel Networks representative and the company who delivered the
equipment.
This procedure is now complete
.
October 2003
MICB card slots
All available IPE card slots.
IPE card slots 0, 4, 8, and 12.
1, 2, or 3 of the Succession Media
Gateway, or slots 7, 8, 9, or 10 of the
Succession Media Gateway Expansion.