Nortel Remote Gateway 9150 Installation And Administration Manual page 138

Installing the Remote Gateway 9150 unit
6 Connect the ADMIN connector on the Remote Gateway 9150 unit to the
administration PC as follows:
a. Connect the male 9-pin connector of the supplied RS-232 serial cable
b. Connect the other end to an available COM port on the PC.
7 Connect the Remote Gateway 9150 unit to the power source as follows:
a. Connect the four-pin plug on the power transformer to the POWER
b. Connect the AC cord to the AC power receptacle on the power
c. Plug the AC cord into a 110 V or 220 V uninterruptible power source
8 Proceed with "Powering up the Remote Gateway 9150 unit" on page 111.
110
to the ADMIN connector on the Remote Gateway 9150 unit.
Note: You may need to provide an RS-232 adapter if the available
RS-232 port on your PC does not match the connector on the serial
cable.
connector on the Remote Gateway 9150 unit.
Note: Ensure the arrow on the four-pin plug faces up.
transformer.
(UPS) or wall outlet.
Remote Gateway 9150 Installation and Administration Guide
Standard 4.0