Nortel Remote Gateway 9150 Installation And Administration Manual page 123

June 2005
The following diagram shows where you can install the trunk interface and DSP
application modules on the Remote Gateway 9150 unit circuit board:
Nortel recommends that you populate each module position in sequential order.
Install trunk interface modules according to the Telco 1 or Telco 2 connections
used.
Note: The Remote Gateway 9150 unit contains a dongle socket located in the
middle of the circuit board. This dongle is not being used.
Remote Gateway 9150 Installation and Administration Guide
Trunk interface modules
Telco 2
6 7
3 2
DSP modules
Installing the Remote Gateway 9150 unit
Telco 1
4 5
1
G101408
95