Nortel Remote Gateway 9150 Installation And Administration Manual page 196

Using Configuration Manager
3 Do one of the following:
Enter the IP address of the unit that you want to connect to in the IP
Address fields.
Note: This option is available when you are logged on to any Remote
Gateway 9100 Series unit.
Enter the unit ID of the unit that you want to connect to in the Unit ID
field.
Note: This option is only available when you are logged on to an RLC.
Use this option when accessing a Remote Gateway 9100 Series unit
located behind a NAT router or Firewall device.
4 Click on the OK button.
Result: Configuration Manager initiates a connection attempt. The
following message can appear:
Trying to Connect to <IP address> or <unit ID>
Refer to "Logging on to a unit" on page 157 for more information.
When you complete your work on a unit, you must log off from that unit.
Execute a Connect → Logoff Unit command for each unit that you logged on to
before ending your Configuration Manager session.
168 Remote Gateway 9150 Installation and Administration Guide
Standard 4.0