Nortel Remote Gateway 9150 Installation And Administration Manual page 215

June 2005
In the following example there are three different values for XCAD. Collect the
LD 56 WCAD details for each different XCAD value.
>ld 56
REQ prt
TYPE FCAD
WCAD 0
CDNC 00000 00000 00000 00000 00000 00000 00000 00000 0000 00000
END OFF
WTON NO
REQ prt
WCAD 30
CDNC 100 50 00000 ...
END REPT
CYCS 1
WTON NO
REQ prt
WCAD 32
CDNC 102 102 205 819 00000 ....
END REPT
CYCS 1 2
WTON NO
Note the values printed for CDNC, END, and CYCS.
If END = REPT, then the value entered into the End Repeat field is "Repeat".
CYCS usually has "1" or "1 2". Enter the largest number as the No. of Cycles.
Enter the non-zero CDNC values into the Cadence Time fields.
Getting there
9150
Remote Gateway 9150 Installation and Administration Guide
for XCAD 0
→
Configuration Manager
Configuring the Remote Gateway 9150 unit
→
9150 System Configuration
187