Nortel Remote Gateway 9150 Installation And Administration Manual page 193

June 2005
6 Click on the OK button.
Result: The connection attempt is initiated. The following message might
display:
Trying to Connect via Serial Port <port number>
IF the logon attempt
fails,
is successful,
Remote Gateway 9150 Installation and Administration Guide
THEN
the following message displays:
SERIAL CONNECTION FAILED
Check the serial port connection and ensure it is
good. Then, go back to step 1.
the User Logged In dialog box displays.
Click on the OK button.
Result: The Startup Information dialog box
displays.
Messages display above the progress bar at the
bottom of the dialog box, similar to the following:
Reading Hardware Information
Reading DSP Load Data
Reading Configuration Data
These messages mean that Configuration
Manager is obtaining the unit's configuration
information from Flash memory.
When initialization is complete, the
Configuration Data Read Successfully
message displays above the progress bar.
Click on the Close button.
Using Configuration Manager
165