Nortel Remote Gateway 9150 Installation And Administration Manual page 341

June 2005
Ethernet Interface Statistics field descriptions
The following table describes the statistics found on the Ethernet Interface
Statistics screen:
Column
Channel
LAN Drv
Admin
Oper
IfcType
IfcNo
MTUlen
Speed
Rx Octet
Rx Ucast
Rx Mcast
Remote Gateway 9150 Installation and Administration Guide
Description
Identifies the Ethernet device that the statistics on that
line apply to.
The valid values are is1.
Identifies the LAN driver used by the call.
Identifies the administrative state of the port.
Valid values are 1 (Enabled) and 0 (Disabled).
Identifies the operational state of the port.
Valid values are 1 (Up) and 0 (Down).
Identifies the interface type used by the call.
Identifies the Ethernet interface used by the call.
The valid value is 1 (CLAN).
Identifies the Maximum Transmission Unit for this
interface in bytes.
Identifies the data rate of this interface in Mbps.
Identifies the number of bytes received on the given
channel since the statistics were last reset.
Identifies the number of packets with a unicast
Ethernet address that directly matches the Ethernet
address of the identified unit. This statistic describes
the period of time since the statistics were last reset.
Identifies the number of multicast packets received.
These packets can be broadcast MAC addresses for
protocols such as ARP, as well as multicast packets
for group-oriented transmissions such as IP Multicast.
This statistic describes the period of time since the
statistics were last reset.
Administration
313