Review Of Disablements; Review Of Running Tests - Teletek electronics SIMPO Operation And Maintenance Manual

SIMPO Addressable Fire Alarm Panel – Maintenance Menus
item 2.1. The total number of active faults is displayed at the bottom right corner of the screen. Use button (1) to go back
to ALARMS mode and reviewing the alarm messages.
To review the FAULTS at active alarms in the system:
To exit the review fault events mode, press CANCEL button.

2.3. Review of Disablements

The messages for disablements are displayed with normal priority. If no alarm or fault events are present, and there are
active disablements in the system, the DISABLED mode is blinking together with the number of the first disablement.
The LED 'Disable' is lighting on.
Example:
The User can review also some additional information for each of the disablements. For this, select the number of the
disablement message using up/ down arrow buttons (the number of the selected event is blinking) and press ENTER
button.
In case, there are active alarms and/ or faults in the system, but you want to review the disablements, press button (3) –
DISABLED mode. The disablements in the system are displayed with serial numbers. The reviewing is the same as
described in item 2.1. The total number of the introduced disablements is displayed at the bottom right corner of the
screen. Use button (1) to go back to ALARMS mode and reviewing the alarm messages.
To review the DISABLED at active alarms and/ or faults in the system:
To exit the review fault events mode, press CANCEL button.

2.4. Review of Running Tests

The messages for running tests are displayed with normal priority. If no alarm or fault events or disablements are
present, and there are active tests in the system, the TESTS mode is blinking together with the number of the first
running test. The LED 'Test' is lighting on.
The numbers of the zones in test mode with activated detectors are blinking.
Example:
7