Review Of Warning Messages - Teletek electronics SIMPO Operation And Maintenance Manual

SIMPO Addressable Fire Alarm Panel – Maintenance Menus
The User can review the number of the zone in test mode. For this, select the number of the zone using up/ down arrow
buttons (the number of the selected event is blinking) and press ENTER button.
If, there are active alarms and/ or faults in the system and you want to review the running tests, press button (4)
MORE>> – TESTS mode is blinking. The tests running in the system are displayed with serial numbers. The reviewing is
the same as described in item 2.1. The total number of the running tests is displayed at the bottom right corner of the
screen. Use button (1) to go back to ALARMS mode and reviewing the alarm messages.
After choosing the button (2) TESTS the screen displays:
To exit the review of running tests mode, press CANCEL button.

2.5. Review of Warning Messages

The messages for warnings are displayed with low priority. If no alarm or fault events or disablements and tests are
present, and there are active warnings in the system, the WARNINGS mode is blinking together with the number of the
first message. There is no LED indication on the front panel.
Example:
The User can review also some additional information for every warning message. For this, select the number of the
message using up/ down arrow buttons (the number of the selected event is blinking) and press ENTER button. On the
screen is displayed information for the loop number (L:), zone number (Z:) and the address and name of the device (D:)*.
At the bottom of the screen is displayed the date and time of occurring of the warning. Note that the additional
information is different according the type of the warning event.
* NOTE: If the device is an input-output module the number of activated input/output is displayed after the address. For
example, the screen displays message: "Loop Device Input Active - L:1; Z:1; D:3.1", where after the address of the
device is displayed and the number of the activated input of the module. In the example the address of the module is 3
and the number of activated input is 1. The name of the input will be displayed at the end of the message.
In case, there are active alarms and/ or faults in the system, but you want to review the warnings, press button (4)
MORE>> – (3) WARNING mode. The warning messages in the system are displayed with serial numbers. The reviewing
is the same as described in item 2.1. The total number of the warnings is displayed at the bottom right corner of the
screen. Use button (1) to go back to ALARMS mode and reviewing the alarm messages.
To review the WARNINGS at active alarms and/ or faults in the system:
8