Installation; Mounting The Outboard Motor On Boat - TOHATSU MFS 75A Owner's Manual

INSTALLATION

ENOM01800-0
1. Mounting the outboard
motor on boat
ENOW00961-0
WARNING
Do not over-power the boat and take care
not to over-load the engine. Boat manufac-
turers specify the maximum allowable engine
power and complement of their boat in
accordance with certain standards and show
the data on the plate attached to the boat.
For unknown matters, if any, inquire to the
manufacturer of the boat.
ENOW00962-0
WARNING
Never use boat equipped with an outboard
motor that outputs power exceeding the
maximum allowable limit specified by the
manufacturer of the boat, or the following
problems can occur:
The boat can go out of control.
The buoyancy property of the boat varies
from the designed value if the boat is
overloaded especially at the transom.
The boat may crack or be damaged
around the transom.
Over-powering boats can cause serious
injury, fatal accident and/or serious damages
to the hull.
Mounting outboard motor must be per-
formed by trained service person(s) in
well-equipped place where lift or hoist
can be used.
ENOM00025-0
Position ... Above keel line
Place the outboard motor in the center
of the boat's transom.
1
1. Center of boat
2. Chine
ENOM01801-0
Transom matching
Be sure that the anti ventilation plate of
the outboard motor should align with the
bottom of the hull or should not exceed
more than 30mm (1.2in) below the bot-
tom of the hull.
If the above condition cannot be met due
to the shape of the bottom of your boat,
please consult your authorized dealer.
1. Bottom of hull
2. Anti ventilation plate
ENOW00007-1
CAUTION
Before running test, check the boat with
maximum loading capacity. Overloading or
incorre c t weight distr ibution of the
weight may result in boat to lose control,
even swamping or capsizing. Make sure
2
ENOF02406-0
1
0−30 mm
(0−1.2 in)
2
ENOF00015-C
21
5