TOHATSU MFS 75A Owner's Manual page 76

76
INSPECTION AND MAINTENANCE
Be sure to lock the outboard motor in the
tilt up position, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
Do not go under outboard motor in the tilt
up position and locked, or accidental fall
of outboard motor could lead to severe
personal injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the
lower oil plug hole, and fill with gear
oil by squeezing the oil tube until oil
10
flows out of the upper plug hole and
bubbles is disappeared to remove the
air.
ENON00033-1
Note
Use genuine gear oil or the ones recom-
mended (API GL-5: SAE #80 to #90).
Required volume: approx. 1000 mL.
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque
4N·m (3 ft
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOF00927-0
ENOF00100-A
· ·
lb, 0.4 kgf m)
CAUTION
ENOF00101-A