TOHATSU MFS 75A Owner's Manual page 86

86
INSPECTION AND MAINTENANCE
ENOW00969-0
When transporting or storing the outboard
motor, it places only in a vertical position
(normal running position).
ENOM00950-0
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh fuel. If the fuel tank is only
partially filled, air in the tank can cause
10
the fuel to deteriorate during storage.
1. Before adding fuel stabilizer additive,
dr ain th e vap or se par a tor ( S e e
page 86).
2. Follow the instructions on the label
when adding the fuel stabilizer addi-
tive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
ENOF02421-0
CAUTION
4. Turn the engine OFF
ENON00945-0
Note
Over time, oxidation of gasoline can form
buildup of harmful solids called gums.
Water and impurities in the fuel system
can cause corrosion. To stabilize the fuel
and prevent oxidation, gum buildup, and
corrosion throughout the boating season,
recommended to add a good fuel stabilizer
to the fuel tank after each fill up.
ENOM00970-0
Fuel system draining
ENOW00028-A
WARNING
For details on handling fuel, contact an
authorized dealer.
Fuel and fuel vapors are extremely flamma-
ble and can be explosive.
If fuel is spilled, wipe it up immediately.
Keep the fuel tank well away from sources
of ignition, e.g. sparks or open flames
Perform all work outdoors or in a well
ventilated place.
ENOW00097-0
WARNING
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
d an c e w i t h l o c a l f ir e p r e v e n t i o n an d
environment protection regulations.
ENOM01824-0
1. Disconnect the fuel hose from the
outboard motor.
2. Turn the top cowl hook levers to
unlock, lift and remove the top cowl.
3. Pull out the vapor separator drain
hose to outside the bottom cowl.
4. Place an appropriate fuel container
under the drain hose end.