TOHATSU MFS 75A Owner's Manual page 71

Description
Propeller
Shear pin/Split
pin
Gear oil
Lower Unit
Water strainer
Water pump
impeller
Water pump
housing*1
Throttle cable
Throttle link
Shift/
Throttle
Shift cable
Shift link
Power trim & tilt
Warning system
Stop switch
Meters
Bolt, Nut
Sliding Part/Rotation part
Grease nipple
Outer equipment
Anode (engine)
Anode (except for engine)
Top cowl/Ratch
*" " This procedure can be performed by end user.
*" " This procedure shall be carried out by the dealer.
Outboards used in rental, commercial, or other under severe condition as described
below in detail require more frequent inspections and maintenance than shown in this
manual.
Continuous operation at maximum engine speed
Continuous operation at idling or trolling speed
Operation without appropriate warm up
Stopping without sufficient time for the engine to cool down
Frequent sudden acceleration and sudden deceleration
Frequent stop start operation
Frequent shifting operation
Frequent operation in acidic, polluted, muddy, sandy, or shallow water
Appropriate maintenance can prolong your engine life.
Consult your Tohatsu authorized dealer for suitable maintenance interval depending on
operating and environmental conditions.
Inspection intervals
First 20 Every 50 Every 100 Every 200
hours or 1 hours or 3 hours or 6 hours or 1
month months months year
Replace Replace
/
Replace
/ /
/
INSPECTION AND MAINTENANCE
Every 400
Inspection procedure
hours or 2
year
Check/Replace if necessary.
(Seepage 77)
Check/Replace if necessary
Change and replace. (See
page 75)
Check
Check/Replace if necessary.
Check/Replace if necessary.
Check/Replace if necessary.
Check and adjust.
Check/Replace if necessary.
Check and adjust.
Check & replenish
Check
Check
Check
Retighten
Apply grease. (See page 84)
Pump in grease
Check
Check/Replace if necessary.
Check/Replace if necessary.
/
Check and adjust.
71
Remarks
Approx.1000 mL
(34 fl.oz.)
10