TOHATSU MFS 75A Owner's Manual page 55

1. Trim rod
Tilt down
1. Release the tilt stopper from the set-
up position while slightly tilting up
outboard motor.
2. Operate the Power Trim & Tilt switch
and tilt the outboard motor down
until the motor touches to the thrust
rod.
The outboard motor can also be tilted up
and down using the switch provided on
the bottom cowl.
It is possible to tilt up or down whether or
not the main switch is "ON" or "OFF".
ENOM00940-1
Manual relief valve
If the battery is dead, and/or the power
tilt switch is inoperative open the manual
valve completely in the Manual direction.
This allows the outboard motor to be
tilted manually.
1 ENOW00872-1
ENOF02416-0
Make sure the manual relief valve is closed
before operating the outboard motor. If the
manual relief valve is not closed, the out-
board motor will be tilted up when shifting in
reverse.
ENOW00873-1
Before opening the manual relief valve, make
sure nobody is under the outboard motor. If
the outboard motor is in the tilted upposi-
tion with the manual relief valve loosend, the
outboard motor will be tilted down suddenly.
ENOF02417-0
1. Power
2. Manual
Manual relief valve specified torque:
3 N - m (2.2 ft
ENGINE OPERATION
WARNING
WARNING
1
2
ENOF00679-0
- lb, 0.3 kgf - m)
55
7