TOHATSU MFS 75A Owner's Manual page 35

ENOM00126-A1
Remedy
1.
Reduce the speed to less than half
open throttle, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
age on blades.
Consult an authorized dealer if engine
shows the same result even after
replacing propeller with a new one.
2.
Move to safe place quickly, and stop
the engine until it cools down.
Check the engine oil level, and add
engine oil if necessary.
Consult your dealer if the engine oil
level is too low or too high.
3.
Move to safe place quickly, and check
if cooling water is discharged from
the water check port at idle speed
and stop the engine.
Remove any foreign matter on the
gear case and propeller if necessary.
Consult an authorized dealer if no
discharge of cooling water.
4.
Consult an authorized dealer.
5.
Replace the engine oil (See page 72)
and reset the indicator (See page 35).
PRE-OPERATING PREPARATIONS
ENOM00870-0
Engine oil replacement indicator
function reset method
As for "Engine oil replacement indicator
function", informing the appropriate
timing of engine oil replacement by
blinking of the lamp, when beyond 100
hours operating.
1. Be certain the safety lanyard is
installed. Turn the key to the 'on'
position and after the 'beep' pull the
safety lanyard off.
2. Within 5-10 seconds, pull the red
knob on the safety switch out and
release.
3. Wait 5-10 seconds and pull the red
knob out and release.
35
1 Second
ENOF00853-0
ENOF00854-0
ENOF00854-0
6