TOHATSU MFS 75A Owner's Manual page 73

8. Fill the engine through the filler port
with the recommended trapped oil to
between the upper and lower limit
mark on the dipstick.
9. Tighten the oil filler cap.
10. Leave the outboard motor for 5 min-
utes and check oil level on the dip-
stick. Add oil if necessary.
11. Insert the dipstick to the hole com-
pletely and install the top cowl.
12. Start the engine and idling for 5 minu-
ets, then check for no oil leaks and no
warning indicate.
1
3
1. Oil filler cap
2. Dipstick
3. Filler port
1. Upper limit 4200 mL (4.4/3.7 US/Imp qt.)
2. Lower limit 2200 mL (2.3/1.9 US/Imp. qt.)
Oil volume needed for complete oil replacement
ENOW00925-0
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
2
ENOF02407-0
1
2
ENOF02432-0
INSPECTION AND MAINTENANCE
ENON00920-0
Note
Use only recommended engine oil (See
page 29)
With oil filter
replacement
Approximately 4.2 L
(4.4/3.7 US/Imp. qt.)
CAUTION
ENON00031-0
Note
If any amount of water is found in
engine oil, making it milky white, consult
dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
73
Without oil filter
replacement
Approximately 4.0 L
(4.2/3.5 US/Imp. qt.)
10