TOHATSU MFS 75A Owner's Manual page 53

UP
DN
ENOM01818-0
Improper trim angle (bow dips into the
water)
When the trim angle is too small, the bow
will dip into the water, the speed will
decrease, and water may enter the boat.
Increase the trim angle by pressing "UP"
of power trim & tilt switch.
ENOM01819-0
Trim meter
When the trim angle is set as desired,
take a reading off the trim meter, and
record it for future reference.
ENOM01820-0
Trust rod adjustment
The trim angle at full tilt down is adjust-
able by selected the thrust rod position.
ENOF00941-0
1. Thrust rod
2. Higher
3. Lower
1. Stop the engine.
2. Shift into neutral position.
3. Tilt up the outboard motor.
ENOF00053-0
4. Lock the tilt stopper.
5. Remove the Snap pin and thrust rod
as shown in the picture.
1. Snap pin
2. Thrust rod
JNOF00807-1
6. Reinstall the thrust rod in the desired
position securely.
7. Put the Snap pin back and unlock the
tilt stopper.
8. Gently tilt down the outboard motor.
ENGINE OPERATION
2
3
1
53
1
ENOF02413-0
7
2
ENOF02414-0