References to the Model 800 assume that it has been upgraded to a Series III.
The Intellec Series III must have the following configuration:
•
An integral system console
•
Two double-density disk drives
•
The iSBC 012B memory board
•
An expansion chassis (MDS-201)
The III-820 board must be installed before the iLTA can run on an Intellec Series III.
The Intellec Series IV must have the following configuration:
•
An integral system console
•
A hard disk—this can be the integral 5.25 in., lOM-byte Winchester disk drive or a 32M-
byte peripheral Winchester disk drive
•
The iSBC 012B memory board
•
A 5.25 in., double-density disk drive
The IBM PC/XT and PC/AT must have the following configuration:
•
2A at 5VDC available for the PICE host interface board
•
A hard disk
•
At least 512K bytes of RAM (of which 384K bytes must be available for the PICE
software)
•
The ability to read 5 1/4 in., double-density disks (48 tpi)
•
PC-DOS version 3.0 or later
•
An open card slot (excluding slot J8 on the PC XT) for the PICE-to-PC interface board
•
I/O address space 120 - 13F (hexadecimal) available for the PICE system
System Performance
Mappable zero wait-state memory:
Trace buffer:
Virtual symbol table:
1-18
NOTE
Minimum 32K-bytes
1023 x 48 bits
The number of user program symbols is limited only by
available disk space.
PICE™ System Overview