Installing the Emulation Clips Module
After your personality modules are installed, perform the following steps to install the emula
tion clips module.
1. Connect the terminator assembly to the emulation clips module (P2 to J2) (see Figure
A-17).
2. Install as many microhooks as needed for the system on the wires of the terminator assem
bly (see Figure A-17).
3. Feed the W5P1 end of the emulation clips cable through the external strain relief, then
through the left-hand slot at the lower front of the instrumentation chassis, through the
internal strain relief, and connect W5P1 to jack J1 on the break/trace board (see Figures
A-4 and A -18).
If you have multiple PICE chassis, install the emulation clips on the other chassis.
This completes installation of the emulation clips module. If you have the iLTA logical timing
analyzer option, go to the next section. If you do not have this option, remove any unnecessary
slack from the probe cables and any other chassis cables. Secure the cables to the bottom of the
instrumentation chassis with the supplied cable clamps; then skip the next section and go to the
Host Installation section.
A-18
Figure A-17 Assembling the Emulation Clips Module
PICE™ System Non-Host Hardware Installation