Intel l2ICE User Manual page 182

Figure A-11 The Correct Orientation of the 8086/8088 User Cable
2. Connect the ribbon cable from J6 of the buffer board to J2 of the personality board (see
Figure A-12).
3. Install the indicated jumpers for the emulator configuration (see Figure A -13):
E l 7-El 8 for 16-bit emulation (80186)
E 16-E17 for 8-bit emulation (80188)
4. Verify that the proper microprocessor chip (80186 or 80188) for the emulator configura­
tion is in the U 19 socket of the personality board. Note that this is a bond-out chip available
only from Intel. The U 19 socket is on the personality board; the PGA socket on top of the
buffer box is reserved for the user cable in loopback mode.
The microprocessors supplied with the probes are special FICE components. To
avoid problems and potential damage, do not use standard production microproces­
sors with the FICE system.
5. Connect the two halves of the buffer box and secure with two screws, lockwashers, and
washers.
A-12
FICE™ System Non-Host Hardware Installation
1210