System Memory - Intel NUC 13 Extreme Kit NUC13RNGi9 User Manual

3.0

System Memory

Intel® NUC 13 Extreme Kit NUC13RNGi9, NUC13RNGi7, NUC13RNGi5 and Intel® NUC
13 Extreme Compute Element NUC13SBBi9, NUC13SBBi7, NUC13SBBi5 have two
262-pin DDR5 SO-DIMM sockets. Be sure to select memory modules that meet these
requirements:
•
•
•
•
•
Find compatible memory modules in the Intel Product Compatibility Tool
•
•
•
•
•
•
NOTE
To install memory, follow these steps:
1. Observe the precautions in "Before You Begin" on page 5.
2. Turn off all peripheral devices connected to the computer. Turn off the
3. Remove the computer's side and top chassis covers as per the instructions in
4. Align the small space (key) at the bottom edge of the memory module with
5. Insert the bottom edge of the module vertically into the socket (A)
6. When the module is inserted, push up the retaining clips until they snap into
NUC13RNGi9, NUC13RNGi7, NUC13RNGi5, NUC13SBBi9, NUC13SBBi7, NUC13SBBi5.
User Guide – July 2023
1.1V and 2.1V (with XMP) low voltage JEDEC memory only
4000 MHz, 4400 MHz, 4800 MHz, 5200 MHz, and 5600 MHz SO-DIMMs
Max capacity - 64GB
Non-ECC
Intel® XMP 3.0 support
NUC13RNGi9
NUC13RNGi7
NUC13RNGi5
NUC13SBBi9
NUC13SBBi7
NUC13SBBi5
If you plan to install only one memory module, install it in the lower
memory socket.
computer and disconnect the power cord.
section 2.0, Open the chassis.
the key in the socket.
place (B). Make sure the clips are firmly in place.
13