Install And Remove System Memory; Install So-Dimms - Intel NUC 13 Pro Desk Edition User Manual

3.0

Install and Remove System Memory

Intel® NUC 13 Pro Desk Edition Kit NUC13VYK has two 260-pin DDR4 SO-DIMM
memory slots
Memory requirements:
•
•
•
•
Find compatible system memory modules at the Intel® Product Compatibility Tool:
• Intel® NUC 13 Pro Desk Edition Kit NUC13VYKi7
• Intel® NUC 13 Pro Desk Edition Kit NUC13VYKi5
3.1

Install SO-DIMMs

If you plan to install just one SO-DIMM, install it in the lower memory
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" in Section 1.1.
2. Turn off all peripheral devices connected to the computer. Turn off the
computer and disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in
the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the
SO-DIMM until the retaining clips snap into place. Make sure the clips
are firmly in place.
Intel® NUC 13 Pro Desk Edition Kit NUC13VYK
User Guide – May 2023
1.2V low voltage memory
2400/2666/3200 MHz SO-DIMMs
Non-ECC
Up to 64GB of system memory supported with 2 SO-DIMMs using 32GB memory
modules
8
socket.