Install And Remove System Memory; Install So-Dimms - Intel NUC Kit NUC1ATKPE User Manual

3.0

Install and Remove System Memory

Intel NUC Kits NUC11ATKPE, NUC11ATKC4, and NUC11ATKC2 have two 260-pin
DDR4 SO-DIMM memory slots
Memory requirements:
 1.2V low voltage memory
 2933 MHz SO-DIMMs
 Non-ECC
 Up to 32 GB total (2x 16GB memory modules)
Find compatible system memory modules at the Intel® Product Compatibility Tool:
 NUC11ATKPE
 NUC11ATKC4
 NUC11ATKC2
3.1

Install SO-DIMMs

If you plan to install just one SO-DIMM, install it in the lower memory socket.
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" in Section 1.1.
2. Turn off all peripheral devices connected to the computer. Turn off the
computer and disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in
the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the
SO-DIMM until the retaining clips snap into place. Make sure the clips
are firmly in place.
NUC11ATKPE, NUC11ATKC4, NUC11ATKC2
User Guide - January 2022
8