ProSoft Technology inRAX MVI56E-MNETCR User Manual page 110

Reference
User Manual
Cold Boot Block (9999)
This block is equivalent to performing a hardware reset, and causes the module
to restart in the same way as if the power was cycled. The Cold Boot control
block also reloads the module's backplane and application port drivers, restarts
the program, and resets all internal registers to zero.
Note: In some cases, the read section of the module database (transferred from module to
processor) must keep its values after a reboot. To repopulate the module's registers with the last
values the module sent to the processor, set the I
configuration to Y
The following table describes the format of the control block.
Offset
0
1 to 41
The module does not send a response block for this command.
Page 110 of 159
Modbus TCP/IP Multi Client Enhanced Communications Module for Remote Chassis
.
ES
Description
9999
Spare
MVI56E-MNETCR ♦ ControlLogix Platform
O D parameter in the module
NITIALIZE UTPUT ATA
Length
1
41
ProSoft Technology, Inc.
June 14, 2011