Reinstall The Gc Panels - Thermo Scientific NPD Tandem Upgrade Kit Installation Manual

Upgrade Kit
NPD Tandem Detector
Connecting the Detectors Cables
9. Carefully, connect the signal and ignition polarization cables coming from the

Reinstall the GC Panels

This operation allows to reinstall the GC panels
Material needed:
•
1. Reinstall all the GC panels proceeding in the reverse order of their removal
30
detector control card, to the NPD detector cell, then the signal, excitation and
heater cables to the ECD detector cell as shown in Figure 1-27.
1. NPD Signal Cable
3. ECD Signal Cable
5. ECD Heater Cable
Figure 1-27. Detector Cables Connections
3-mm Allen wrench
(refer to Removing the GC Panels
panel cooling fan.
1
2
5
3
4
2. NPD Ignition Polarization Cable
4. ECD Excitation Cable
on page 9) being sure to reconnect the rear
Getting Started
Installation Guide