Table of Contents
Advertisement
Upgrade Kit
NPD Tandem Detector
4. Install the provided heating block on the top of the ECD and fix it with its
5. Slip the heat shield onto the heating block.
6. Connect the heating cable connector to the relevant connection port marked
Placing the NPD Jet
NOTE
The use of the Silcosteeled jet is suggested when you operate in NPD Tandem
configuration in order to avoid any analytes breakdown.
7. Place the jet for NPD into the detector adapter housing and tighten it with the
CAUTION
I.Ensure the jet is perfectly vertically aligned.
28
Allen screw by using the 3-mm Allen wrench as shown in Figure 1-25.
1. Heating Block
3. Heat Shield
located on the top of the NPD control card.
Heater
proper tool as shown in Figure 1-25.
2
2. Heating Cable
Figure 1-24. Mounting the Heating Block
Getting Started
3
1
Installation Guide
Advertisement
Table of Contents
