Table of Contents
Advertisement
Upgrade Kit
NPD Tandem Detector
Set NPD Parameters
To set NPD parameters, it is necessary to open the AUX menu and the AUX
Signal menu.
•
•
OPERATING SEQUENCE
NPD Parameters Setting
This operating sequence contains an example of parameters setting for the NPD
configured as auxiliary detector.
1. To open NPD menu, press AUX DETECTOR The following menu is displayed:
2. To open AUX Signal menu, press AUX SIGNAL. The following menu is
34
The
AUX DETECTOR (NPD)
NPD. To set parameters, refer to the Chapter 19 of the TRACE GC Ultra
Operating Manual.
The
AUX SIGNAL (NPD)
NPD detector signal. To set parameters, refer to the Chapter 16 of the TRACE
GC Ultra Operating Manual.
Source curr.A
Base temp
Signal pA
Target curr. pA
Auto Adjust
Polarizer V
H2 delay time
H2
Air
1. This parameter line will be displayed according to the Range parameter
in the AUX SIGNAL menu. See
displayed:
menu contains the control parameters for the
menu contains the parameters that control the
AUX DETECTOR (NPD)
300
1
2
Range Parameter
Set NPD Parameters
2.500
300
(10.4)
(3.00)
No
3.5
Off
2.3
2.3
60
60
on page 35
Installation Guide
Advertisement
Table of Contents
