Upgrade Kit
Nitrogen Phosphorus Detector
Reinstall the GC Panels
This operation allows to reinstall the GC panels
Material needed:
•
1. Reconnect the chassis ground wire to the GC rear oven terminal.
2. Reinstall all the GC panels proceeding in the reverse order of their removal
22
1. NPD
3. Detector base body
5. Ignition polarization cable
3-mm Allen wrench
(refer to
Removing the GC Panels
panel cooling fan.
1
2
3
2. Fixing screw
4. Signal cable
Figure 1-13. Installation of the NPD
on page 9) being sure to reconnect the rear
Getting Started
4
5
Installation Guide