Figure 1-3 Trace Gc Ultra Rear Panel - Thermo Scientific NPD Tandem Upgrade Kit Installation Manual

Getting Started
Remove the Pneumatic Compartment Panel
1. Loosen and remove the three screw that secures the pneumatic compartment
Remove the GC Rear Panel
1. Locate the six Allen screws that secure the rear panel to the GC. Remove
2. Carefully remove the rear panel of the GC. Be aware that the cooling fan is
NOTE Pay attention to the positioning of the cooling fan plug, so it can be reconnected in the
same way it was removed.
Installation Guide
1. Right Panel Securing Screw
Figure 1-3. TRACE GC Ultra Rear Panel
panel to the rear of the GC by using the 3-mm Allen wrench. Refer to
Figure 1-3.
these screws using the 2-mm Allen wrench. See Figure 1-4.
attached to the rear panel.
2. Pneumatic Compartment Securing Screws
Upgrade Kit
NPD Tandem Detector
11