Figure 1-2 Trace Gc Ultra Top Cover - Thermo Scientific NPD Tandem Upgrade Kit Installation Manual

Upgrade Kit
NPD Tandem Detector
Remove the GC Top Cover
1. Lift the detector cover off the GC top cover.
2. Open the oven door and unscrew the two top cover fastening screws.
3. Push the cover back about 1 cm and lift it up and off the GC.
Remove the GC Right Side Panel
1. Loosen and remove the screw that secures the right side panel to the right
2. Slide the side panel towards the back of the GC and then tilt the top of the side
3. Hold the side panel parallel to the GC, and pull the lower edge of the panel
10
Figure 1-2. TRACE GC Ultra Top Cover
upper rear corner of the GC by using the 3-mm Allen wrench. Refer to
Figure 1-3.
panel outwards. Continue to slide the panel towards the rear of the GC.
away from the GC.
Getting Started
Installation Guide