Table of Contents
Advertisement
Set NPD Parameters
Range Parameter
The
sensitivity) to 3 (low sensitivity). The dynamic of the NPD card is as follows:
This means that if we have a small variation (in pA) of the baseline value when
the
If the
detected from the NPD card. For this reason, when the
the
menu.
Installation Guide
Output
Offset
Auto zero?
Range 10^(0..3)
Analog filter
Baseline Comp
parameter is an input attenuation value. It is set from 0 (high
Range 10^
Range
Input Signal
0
1 nA
1
10 nA
2
100 nA
is set 0 or 1, the input amplifier circuit of NPD card can read it.
Range 10^
is set 2 or 3, the small variation (in pA) of the baseline is not
Range 10^
parameter will be not displayed in the
Signal pA
AUX SIGNAL (NPD)
Output Signal
1 Volt
1 Volt
1 Volt
NPD Tandem Detector
(1000)
100
Y/N
0<
Off
Off
is set 2 or 3,
Range 10^
AUX DETECTOR(NPD)
Upgrade Kit
35
Advertisement
Table of Contents
