Adjustable Parameters - APRILIA TUONO R FACTORY 2007 Service Station Manual

Power supply
Adjustable parameters screen page

ADJUSTABLE PARAMETERS

This screen page is used to adjust some control
unit parameters.
Specification
Initialisation
Throttle position self-learning
CO adjustment 1
CO adjustment 2
Engine option
Lambda probe
Idle motor
Initialised control unit
Freeze frame screen page
FROZEN PARAMETERS
These are the values read by the control unit at the
moment when the selected error is detected
Specification
Engine load
Water temperature
Air temperature
P SUPP - 212
ADJUSTABLE PARAMETERS
To zero set the adjustable parameters when the control unit or
the throttle body or the injectors are replaced (it may occur that
during the first seconds after the start-up, it remains at 5000
rpm). The engine start-up number counter, displayed on the
Autodetection by the control unit of the throttle position sensor
and the idle motor (if the sensor or motor are replaced)
Adjustment only through PASSWORD if it is not possible to
Adjustment only through PASSWORD if it is not possible to
Set 1 if you wish to activate the standard mapping; set 2 if you
wish to activate the Racing mapping (only with unmuffled ex-
Adjustment only through PASSWORD: if you wish to deactivate
the lambda probe, regardless of the mapping type
Adjustment only through PASSWORD: if you wish to deactivate
Enabling needed when a new control unit is installed (enables
a series of parameters): the same parameters shown on the
FROZEN PARAMETERS
Unlike the Engine parameter reading screen page, it is ex-
TUONO R_FACTORY
Desc./Quantity
frozen error parameters, is reset
balance the CO with the by-pass screws
balance the CO with the by-pass screws
haust pipes! for instance Akrapovic)
the idle motor
DEVICES SCREEN PAGE can be seen
Desc./Quantity
pressed in %
-
-