TUONO R_FACTORY
•
Insert the pin clip.
Installing the cylinder
•
Place the cylinder base gasket.
•
Fit the piston.
•
Remove the cloth used to prevent for-
eign bodies getting into the crankcase.
•
Turn the rings so that the connection
ends are 120 degrees from each other.
•
Lubricate piston and cylinder.
•
Using a specific tool for piston ring
clamps, place the cylinder.
CAUTION
DURING THIS OPERATION, PAY ATTENTION NOT TO
DAMAGE THE PISTON.
Specific tooling
8140186 Piston ring clamp tool
•
Remove the tool for piston ring clamps and finish positioning the cylinder.
Specific tooling
8140186 Piston ring clamp tool
•
Finish fitting the cylinder and the head
by moving the timing chain upwards.
Engine
ENG - 171