APRILIA TUONO R FACTORY 2007 Service Station Manual page 219

TUONO R_FACTORY
•
Remove the right spacer (1).
•
Remove the sealing gasket (2).
•
Remove the circlip (3).
CAUTION
THE CIRCLIP (3) IS FITTED ONLY ON THE WHEEL RIGHT
SIDE.
The spacer end (4) is fitted with slots (A) for the extractor teeth to pass through.
•
Remove the right bearing (5) with the suitable extractor.
Specific tooling
AP8140180 Extractor for bushings
•
Collect the inside spacer (4).
Working from the wheel left side:
•
Remove the sealing gasket (2).
•
Remove the left bearing (6) with the
suitable extractor.
Specific tooling
AP8140180 Extractor for bushings
•
Clean the inside of the hub thoroughly.
CAUTION
WASH ALL THE PARTS WITH CLEAN DETERGENT.
Suspensions
SUSP - 219