Mapping Cos Values To Queues - NETGEAR FS728TS User Manual

Mapping CoS Values to Queues

The CoS to Queue Page contains fields for mapping CoS values to traffic queues. To map CoS values to queues:
1. Click QoS > Mapping > CoS to Queue. The CoS to Queue Page opens.
The CoS to Queue Page contains the following fields:
•
Class of Service — Specifies the CoS priority tag values, where zero is the lowest and 7 is the highest.
•
Queue — Defines the traffic forwarding queue to which the CoS priority is mapped. Eight traffic priority queues are supported.
•
Restore Defaults — Restores the device factory defaults for mapping CoS values to a forwarding queue.
2. Define the queue number in the Queue field next to the required CoS value.
3. Click . The CoS value is mapped to a queue and the device is updated.
Figure 5 - 46: CoS to Queue Page
Page 84