Defining General QoS Settings
The CoS Page contains information for enabling QoS globally and on specific interfaces. After QoS has been configured, the original device QoS
default settings can be reassigned to the interface in the CoS Page.
To enable QoS:
1.
Click QoS > General > CoS. The CoS Page opens:
The CoS Page contains the following:
•
Unit No. — Displays the stacking member for which the QoS information is displayed.
•
CoS Mode — Determines whether QoS is enabled on the device. The possible values are:
Enable — Enables QoS on the interface.
–
Figure 5 - 42: CoS Page
Page 79