Performing Copper Cable Tests - NETGEAR FS728TS User Manual

Performing Copper Cable Tests

The Performing Copper Cable Tests contains fields for performing tests on copper cables. Cable testing provides information about where errors
occurred in the cable, the last time a cable test was performed, and the type of cable error that occurred. The tests use Time Domain Reflectometry
(TDR) technology to test the quality and characteristics of a copper cable attached to a port. Cables up to 120 meters long can be tested. Cables
are tested when the ports are in the down state, with the exception of the Approximated Cable Length test.
To test cables:
1. Click Monitor > Copper Cable. The Copper Cable Page opens:
The Copper Cable Page contains the following fields:
•
Unit No. — Indicates the stacking member for which the copper cable test results are displayed.
•
Interface — Specifies the port to which the cable is connected.
•
Test Result — Displays the cable test results. Possible values are:
No Cable — Indicates that a cable is not connected to the port.
–
Open Cable — Indicates that a cable is connected on only one side.
–
Short Cable — Indicates that a short has occurred in the cable.
–
OK — Indicates that the cable passed the test.
–
•
Cable Fault Distance — Indicates the distance from the port where the cable error occurred.
Figure 5 - 69: Copper Cable Page
Page 110