NETGEAR FS728TS User Manual page 72

The Dynamic Addresses Page contains parameters for querying information in the Dynamic MAC Address Table, including the interface type, MAC
addresses, VLAN, and table storing. The Dynamic MAC Address table contains information about the aging time before a dynamic MAC address is
erased and includes parameters for querying and viewing the Dynamic MAC Address table. The Dynamic MAC Address table contains address
parameters by which packets are directly forwarded to the ports. Interface, VLAN, and MAC Address can sort the Dynamic Address Table.
To configure the Dynamic MAC Address Table:
1. Click Address Table > Dynamic Addresses. The Dynamic Addresses Page opens.
The Dynamic Addresses Page contains the following fields:
•
Address Aging — Specifies the amount of time the MAC address remains in the Dynamic MAC Address table before it is timed out if no
traffic from the source is detected. The default value is 300 seconds.
•
Clear Table — To empty the current values from the table.
•
Port — Specifies the interface for which the table is queried. There are two interface types from which to select.
•
MAC Address — Specifies the MAC address for which the table is queried.
•
VLAN ID — Specifies the VLAN ID for which the table is queried.
•
Address Table Sort Key —Specifies the means by which the Dynamic MAC Address Table is sorted. The address table can be sorted by
address, VLAN, or interface.
•
VLAN ID — Shows the ID of the current VLAN
•
MAC — Displays the current MAC address.
•
Port — Indicates the interface for which the table is currently queried
2. Define the fields.
3. Click . The Dynamic Address Aging field is defined and the device is updated.
Figure 5 - 39: Dynamic Addresses Page
Page 72