Safety Instructions: During Operation; Summary Of Safety Instructions - Endress+Hauser analytikjena multi N/C UVHS Operating Manual

multi N/C UVHS, multi N/C pharma UV
2.4

Safety instructions: during operation

2.4.1

Summary of safety instructions

Insufficiently secured components pose a risk of injury.
¡ During transport, secure the device components as specified in these operating
instructions.
¡ Loose parts must be removed from the system components and packed sepa-
rately.
To prevent health damage, the following must be observed when moving the device
in the laboratory (lifting and carrying):
For safety reasons, two persons are required to transport the device who must
¡
hold the unit by either side of the equipment.
The device does not have any carrying handles. Therefore the device must be
¡
gripped firmly with both hands at the lower end.
¡ Risk of damage to health due to improper decontamination! Perform a profes-
sional and documented decontamination of the device before returning it to An-
alytik Jena. The decontamination report is available from Service when register-
ing the return. Service must refuse acceptance of contaminated devices. The
sender may be liable for damage caused by inadequate decontamination of the
device.
The operator must make sure that the device and its safety equipment is in sound
condition each time before starting up the device. This applies in particular after
each modification or extension of the device or its repair.
Observe the following:
¡ The device may only be operated if all items of protective equipment (e.g. covers
in front of electronic components) are in place, properly installed and fully oper-
ational.
The sound condition of the protection and safety equipment must be checked
¡
regularly. Any defects must be corrected as soon as they occur.
¡ Protective and safety equipment must never be removed, modified or switched
off during operation.
Always ensure free access to the main switch and to the emergency shutdown
¡
switches and locks during operation.
The ventilation equipment on the device must be in good working condition.
¡
Covered ventilation grilles or slots etc. may cause the device to break down or
may cause damage to it.
¡ Modifications, conversions and extensions to the device are only permitted after
consultation with Analytik Jena. Unauthorized modifications can jeopardize the
device's operational safety and may lead to limitations regarding the warranty
and access to customer service.
Keep all combustible materials away from the device.
¡
¡ Caution when handling glass components. Risk of broken glass and therefore risk
of injury!
Ensure that no liquid enters the interior of the device, for example at cable con-
¡
nections. There is a danger of electric shock.
There is a risk of injury in the movement range of the autosampler. For example,
¡
hands or fingers may be crushed. Maintain a safety distance from the autosam-
pler during operation.
Security
11