ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual page 74

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
digital label has its own communication object "Status". This can either be a 1-bit or a 1-
byte object (setting parameter "Object type for status object"). When a telegram is
received on the status object, the digital label changes colour. Which colour the digital
label takes on depends on the parameter settings "Colour for "0" and "1"".
If the operating mode "Orientation illumination" is select, the colour of the digital label
does not support the button function. The colour is specify via the "Colour of orientation
illumination" parameter.
12.23.5 Common parameter – Status feedback object type
Options
The status object can either be set to the size "1 bit" or "1 byte 0 - 100%". 1 bit: With the
setting "1-bit", the communication object "Status" has the size "1-bit". If an ON telegram
is, receive on the object, the digital lab takes on the colour that is stored in the "Colour for
"1"" parameter. If an OFF telegram is received, the digital lab takes on the colour that is
stored in the "Colour for "0"" parameter.
1 byte: With the setting "1-byte 0 - 100%", the communication object "Status" has the size
"1- byte". When a value telegram is received on the object, the digital lab can change
colour. Whether the colour and to which colour will be switched to depend on the
parameter settings "Colour for value ...".
The five adjustable zones have the following behavior:
■ Colour for 0%
■ Colour for value between 1% to value A-1%
■ Colour for value between value A to value B-1%
■ Colour for value between value B to 99%
■ Colour for value 100%
The two threshold values Value A and Value B are specified via the parameters
"Threshold between value 1% to value A-1% and A to value B-1% and "Threshold
between B-1% to value B and value B% to 99%.
12.23.6 Common parameter – Colour or "0", for status feedback object type 1 bit
Options
When the digital label is use for status illumination, it can light up in different colors for
easy identification of the status. This parameter is used to specify the digital label colour
to be light up when "0" is receive on the status GO.
12.23.7 Common parameter – Colour or "1", for status feedback object type 1 bit
Options
1 bit
1 Byte 0 - 100%
Off
Red/orange
Red
Blue
Green
White
Off
Red/orange
73