Application "1-Button Dimming - ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
again, Value 1 is again sent out. The values 1 and 2 are specify via the parameters "Value
1 for rising edge" and "Value 2".
The "Deactivated" setting causes no telegram to be sent out for an operation of the button.
12.7.2 Common parameter – Reaction on falling edge
Options
The application can differentiate between the operation and the releasing of the button.
An operation is designate as "Rising edge" and the releasing is designate as "Falling
edge". The application "1-button switching" makes two separate "Switching"
communication objects available for the left or right side of the button. The value 1 is
always sent out on the first object (Value 1) and the value 2 is always sent out on the
second object (Value 2). The "Reaction to falling edge" parameter specifies whether the
"Value 1 for falling edge" or the "Value 2 for falling edge" is sent out for falling edge.
Alternatively, Value1/Value2 can also be alternatingly set for a rising edge, i.e. after Value
1 was sent (or received), a renewed operation will send out Value 2. After it is operated
again, Value 1 is again sent out. The values 1 and 2 are specify via the parameters "Value
1 for rising edge" and "Value 2".
The "Deactivated" setting causes no telegram to be sent out for an operation of the button.
12.7.3 Objects no
Object name
Switching

Application "1-button dimming"

12.8
The push-buttons have communication objects for switching and dimming. A distinction
is made between a short (switching) and long (dimming) press of the button. In each case,
the application makes a separate set of parameters and communication objects available
for the 1st and the 2nd button. The application allows a lamp to be dim with the one button
and the other button to be assign with other "button-oriented" functions.
12.8.1 Common Parameter – Duration of long operation (ss:ms)
Options
A differentiation can be made between a short or long operation of the button. With a
short operation of the button, the next level forward is switch to in each case. With a long
operation, the first level is activated. Thus, with a long button press a jump back from
every position to the first level is possible, without having to run through the remaining
levels.
Via the "Duration of long operation", the time is specified from which a long button press
is recognized, and the object values are reset. The first level must be set again with a
On
Off
Alternating on/off
Deactivated
Data type
1 Bit DPT 1.001
Time input from 0.3 to 3.0 seconds
Flags
C, W, T, U
37