ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual page 144

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
option is select, the "Fan coil step status" object is activate for receiving the fan speed
level from the fan coil actuator.
12.34.116 Fan coil settings - Fan coil settings heating – Fan speed level 1 to 5 up to
control value heating (0..255)
Options
Note: This parameter is only available if the "Device function" parameter is set
on either "Single device" or "Master device" and the "Control value type" parameter is set
on "Fan coil", and the "Control function" parameter must be set on either "Heating",
"Heating with additional stage", "Heating and cooling" or "Heating and cooling with
additional stages".
- These level settings should be adjusted to match the settings in the fan coil actuator.
- Setting the "Control value type" to "Fan coil" in the control parameters is only useful for
one of either the basic stage or the additional stage. Setting the basic and additional
stage parameters to fan coil is not useful, since the control of only one fan coil actuator
each for heating and cooling is support.
- The "Fan speed level 4 - 5 up to control value (0 - 255) heating" parameters are
available only when the "Number of fan speed levels" is set on "5 levels".
In this parameter, the control values of the controller are assigned to fan speed levels.
This assignment is use if the fan speed levels are transmitted together with the control
values.
12.34.117 Fan coil settings - Fan coil settings heating – Fan stage limit heating for
ECO mode
Options
Note: This parameter is only available if the "Device function" parameter is set
on either "Single device" or "Master device" and the "Control value type" parameter is set
on "Fan coil".
This parameter limits the fan speed level when the system is switch to ECO mode.
Input from 0 to 255
No
Yes
143