ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual page 106

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
Note: This parameter is only available if the "Device function" parameter is set
on "slave device".
To switchover between heating and cooling on the room temperature controller via the 1
bit communication object
12.34.13 Operating functions – Fan coil control during heating mode
Options
Note: This parameter is only available if the "Device function" parameter is set
on "slave device".
To set the fan coil actuator to be in manual fan mode or in automatic fan mode via the 1
bit communication object when in heating mode.
12.34.14 Operating functions – Fan coil control during cooling mode
Options
Note: This parameter is only available if the "Device function" parameter is set
on "slave device".
To set the fan coil actuator to be in manual fan mode or in automatic fan mode via the 1
bit communication object when in cooling mode.
12.34.15 Control heating – Control value type
Options
No
Yes
No
Yes
2-point 1 bit, Off/On
2-point 1 byte, (0/100%)
PI continuous, 0-100%
PI PWM, On/Off
Fan coil
105