ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual page 134

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
This preset is used to limit the manual increase during heating mode.
12.34.89 Changing set value – Maximum manual reduction during heating mode (°C)
Options
Note: Only available when the "Device function" parameter is set on either
"Single device" or "Master device", and the Control function parameter is set on "Heating",
"Heating with additional stage", "Heating and cooling" or "Heating and cooling with
additional stages".
This preset is used to limit the manual reduction during heating mode.
12.34.90 Changing set value – Maximum manual increase during cooling mode (°C)
Options
Note: Only available when the "Device function" parameter is set on either
"Single device" or "Master device", and the Control function parameter is set on "Cooling",
"Cooling with additional stage", "Heating and cooling" or "Heating and cooling with
additional stages".
This preset is used to limit the manual increase during cooling mode.
12.34.91 Changing set value – Maximum manual reduction during cooling mode (°C)
Options
Note: Only available when the "Device function" parameter is set on either
"Single device" or "Master device", and the Control function parameter is set on "Cooling",
"Cooling with additional stage", "Heating and cooling" or "Heating and cooling with
additional stages".
This preset is used to limit the manual reduction during cooling mode.
12.34.92 Changing set value – Resetting of the manual adjustment for receipt of a
basic setpoint
Options
Input from 0 to 9
Input from 0 to 9
Input from 0 to 9
No
Yes
133