ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual page 103

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
12.34.3 General – Interval time for switchover to RTC page (sec)
Options
After non-actuation of the control element the temperature again appears in the display
after the set waiting period.
12.34.4 General – Device function
Options
– Single device: The device is use singly in a room as room temperature controller.
– Master device: At least two room temperature controllers are located in one room. One
device is to be set up as a master device, while the others are to be program as slave
devices / temperature sensors. The master device is to be link to the slave devices using
the appropriately labelled communication objects. The master device regulates the
temperature.
– Slave device/temperature sensor: At least two room temperature controllers are located
in one room. One device is to be set up as a master device, while the others are to be
program as slave devices / temperature sensors. The slave devices are to be link to the
master device with the appropriately labelled communication objects. The slave device
serves the room temperature control functions of the master.
12.34.5 General – Control function
Options
Note: This parameter is only available if the "Device function" parameter is set
on "Single device" or "Master device".
– Heating: For operating a heat-based automatic single-room control. The temperature is
regulated to the setpoint value defined in the parameter. The "Controller type" and
"Heating type" can be program for optimal control.
– Heating with additional stage: In addition to the control function described under heating,
the additional stage enables the activation of an additional heating circuit. This type of
additional stage is use, for example, to heat up a bathroom quickly with floor heating via
a heated towel rack.
Time input from 3 sec to 30 sec
Single device
Master device
Slave device
Heating
Heating with additional stage
Cooling
Cooling with additional stage
Heating and cooling
Heating and cooling with additional stage
102