ABB i-bus KNX Yucus YUB/U1.0.1 Series Technical Reference Manual page 49

KNX Technical Reference Manual
ABB i-Bus ® KNX Yucus
can also be alternatingly set for a rising edge, i.e. after Value 1 was sent (or received), a
renewed operation will send out Value 2. After it is operate again, Value 1 is again sent
out. The values 1 and 2 are specify via the parameters "Value 1" and "Value 2".
The "No reaction" setting causes no telegram to be sent out for a operation of the button.
12.11.7 Extended parameter – Value 1 for failing edge
Options
Note": This parameter is only visible if the "Reaction at failing edge" parameter
is set on either "Value 1" or "Alternating Value1/Value2". The options are dependent on
the setting of the "Object type for failing edge" parameter.
Value 1 options are dependent on the setting of the "Object type for failing edge"
parameter.
– 1 bit: switching functions (e.g. On/Off, enable/blocked, true/untrue)
– 1 byte 0 - 100%: percentage values (0 = 0%, 255 = 100%)
– 1 byte 0 - 255: arbitrary values from 0 to 255
– 2-byte float: floating point value (physical values such as temperature or brightness) -
671088.64 to 671088.64
– 2-byte signed: arbitrary values from -32768 to +32767
– 2-byte unsigned: arbitrary values from 0 to 65,535
– 4-byte float: floating point value (physical values) -4000000 to 4000000
– 4-byte signed: arbitrary values from -2147483648 to 2147483647
– 4-byte unsigned: arbitrary values from 0 to 4294967295
12.11.8 Extended parameter – Value 2 for failing edge
Options
– 1 bit: On/Off
– 1 byte 0 - 100%: (0%-100%)
– 1 byte 0 - 255: 0 to 255
– 2-byte float: -671088.64 to 671088.64
– 2-byte signed: -32768 to +32767
– 2-byte unsigned: 0 to 65,535
– 4-byte float: -4000000 to 4000000
– 4-byte signed: -2147483648 to 2147483647
– 1 bit: On/Off
– 1 byte 0 - 100%: (0%-100%)
– 1 byte 0 - 255: 0 to 255
– 2-byte float: -671088.64 to 671088.64
– 2-byte signed: -32768 to +32767
– 2-byte unsigned: 0 to 65,535
– 4-byte float: -4000000 to 4000000
– 4-byte signed: -2147483648 to 2147483647
48