Adjusting Primary Colors; Dmd Color Correction; Adjusting Color By Precise Chromaticity Values - Christie Mirage 4K40-RGB User Manual

Hide thumbs Also See for Mirage 4K40-RGB:
Table of Contents

Advertisement

Adjusting primary colors

Calibrate the accuracy of primary colors, which can change because of lighting and environmental
factors.
All primary colors in the projector are precisely set to pre-established values to ensure overall color
performance is optimized and is as accurate as possible. Lighting and other environmental factors may
slightly change how these colors appear on your screen. While the change is negligible in most cases,
you may prefer to recover the originally intended color performance before trying to match colors from
several projectors.
To achieve consistency use a color meter to measure the native primary colors—red, green, blue, and
white—as they appear on the screen. On the basis of these new values, which are stored in memory,
each projector automatically calculates any necessary corrections to reproduce the original factory
colors under the current environmental conditions. This essentially calibrates a projector to its
surroundings, compensating for factors such as screen type, light source and/or ambient lighting, and
improves color accuracy and consistency in a group of projectors. It ensures a good starting point for
further customizing and matching; however, is not critical for all installations.
1. From the display panel, select MENU > Configuration.
2. Select Color Primary Settings.
3. To edit the primary colors, select Edit Primary Colors.
4. Adjust the slider or enter the measured color values of the primary color component you
selected.
5. To confirm your selection, select Enter.
6. Repeat steps 5 and 6 for each primary color component.
7. To view a specific color while adjusting, select Show Color Pattern.
8. Select the appropriate color and select Enter.
9. To reset the primary colors to their defaults, select Reset Color Primaries.
10. At the confirmation prompt, select OK.

DMD color correction

Adjust the DMD color values as required.

Adjusting color by precise chromaticity values

Change the values of the primary color components.
1. Select MENU > Configuration > Color Correction by x,y.
2. Adjust the slider or enter the measured color values of the primary color component you
selected.
3. To confirm your selection, select Enter.
4. Repeat steps 2 and 3 for each primary color component.
5. To view a specific color while adjusting, select Show Color Pattern.
6. Select the appropriate color and select Enter.
Mirage 4K40-RGB User Guide
020-103015-05 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Adjusting the image
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

D4k40-rgb

Table of Contents